M Mikael New Member Aug 10, 2010 #1 Once i have the cut out of the part ,out of pepakura, how do i harden it? Im new to this method....
A AceNat Well-Known Member Aug 10, 2010 #2 with resin, a couple of layers should do. then fiberglass or rondo. there are a ton of wip threads about this which actually shows how they do it, best bet is to check them out before asking questions through the blogs
with resin, a couple of layers should do. then fiberglass or rondo. there are a ton of wip threads about this which actually shows how they do it, best bet is to check them out before asking questions through the blogs
