so today i went out to my local hardware store t look at some ribbed hoses that i could cut up to make the side vents on my helmet, i didn't find any at Rona so i thought "well since i'm here..." i went to look at dremel tools and found a good kit for 80$, so i bought it. after that i went to another hardware store and found what i was originally going out for, the ribbed hose.
i also have finished the toe pieces and the H2 hand plates. i am currently working on the cod piece, i have to re glass some spots because the fiberglass didn't bond it the paper right and it was too flimsy.
my dremel tool
it came with a right angle attachment
and 40 bits
and a carrying case, i will need this because my bench is incredibly cluttered
and now for the armor
toe pieces
and the hand plates
i also have finished the toe pieces and the H2 hand plates. i am currently working on the cod piece, i have to re glass some spots because the fiberglass didn't bond it the paper right and it was too flimsy.
my dremel tool
it came with a right angle attachment
and 40 bits
and a carrying case, i will need this because my bench is incredibly cluttered
and now for the armor
toe pieces
and the hand plates