I have seen many people use these before so I decided to post a Tutorial to show people how I did mine.
You will need to adjust the size of the cut plunger based on your boot size.
Supplies (I used the Air to cool the hot glue faster, hold the can upside down to do that)
Toes Armor with Shoe Goo where the plunger will go
Plunger in place with hot glue to hold it snug in place. Just on the top edges and one spot in the middle bottom.
That finishes the plunger portion and here is what this looks like.
Now I will reinforce the spots that I will screw the armor to the shoe (with hot glue).
A screw will go in the tip and I made two spots on the side for side screws if I wanted to add those later.
And here is the finshed product. The heel piece will also be screwed on. You will put some hot glue right on the heel where the screw goes in the heel. My and toe took one screw each.