Props Halo Reach M45 Shotgun

Status
Not open for further replies.

howaado

Active Member
I want to start off by saying thanks to Juliet76 for the blueprints for this gun. I started working on this about 3 weeks ago, and am almost to the point where I'll call it complete. All that's really left is to make and attach the flashlight and holder. It is made of multiple layers of foam with small pieces of metal and pvc pipe for added rigidity throughout the prop itself. The edges were rounded and shaped using my rotary tool with a medium to fine grit sanding drum bit. For the different details thin craft foam and mat board were used and layered to get that look, and binding posts and screws for any of the rivets and screws. It was then sealed using Plasti dip, then painted and weathered. I also put a rail and clip system on the gun and my armor to allow me to carry it around on my back, although I will not be able to put it there on my own due to the restrictions on my movement from my armor. I might go back over it with some brown paints to add some dirt/mud to it, but that will be more of a last minute thing.
 

Attachments

  • WP_20140625_001.jpg
    WP_20140625_001.jpg
    451.7 KB · Views: 467
  • WP_20140701_009.jpg
    WP_20140701_009.jpg
    427.2 KB · Views: 506
  • WP_20140701_012.jpg
    WP_20140701_012.jpg
    354.4 KB · Views: 505
  • WP_20140701_005.jpg
    WP_20140701_005.jpg
    330.2 KB · Views: 417
  • WP_20140707_004.jpg
    WP_20140707_004.jpg
    336.9 KB · Views: 545
  • WP_20140707_007.jpg
    WP_20140707_007.jpg
    398.8 KB · Views: 580
Status
Not open for further replies.
Back
Top