BritKnight
New Member
Greetings and salutations!
I'm working on a full Mk VI suit. I'm planning on 3D printing the helmet (using this model) and pepping the rest of the suit. For the pepped pieces I'm using a somewhat odd mix of HD and SD files (I used HD whenever I thought the extra detail was needed, and when there weren't too many extra pieces). The pep files I'm using are:
So far I have both handplates pepped and part of the helmet printed, and here are the results:
Handplates:
One is definitely more symmetrical than the other...
Helmet:
I'm going to start on the forearms next. Any advice/feedback would be greatly appreciated.
Thanks,
I'm working on a full Mk VI suit. I'm planning on 3D printing the helmet (using this model) and pepping the rest of the suit. For the pepped pieces I'm using a somewhat odd mix of HD and SD files (I used HD whenever I thought the extra detail was needed, and when there weren't too many extra pieces). The pep files I'm using are:
- MD Chest by Robogenesis
- SD Codpiece (also by Robogenesis)
- SD Biceps (again by Robogenesis)
- HD Boots, 3 Pieces (Robogenesis)
- HD Forearms (by Nugget)
- HD Handplates (Robogenesis)
- HD Shins (by crackhead09)
- HD Thighs (by crackhead09)
So far I have both handplates pepped and part of the helmet printed, and here are the results:
Handplates:
One is definitely more symmetrical than the other...
Helmet:
I'm going to start on the forearms next. Any advice/feedback would be greatly appreciated.
Thanks,