Fallout Ripper - Post-Apocalyptic Chainsword

Status
Not open for further replies.

Vrogy

Well-Known Member
This was a quick model I'd been eyeing for a while. Sort of just happened overnight earlier this week. It's based upon the concept art of the ripper by Adam Adamowicz, not the version that appeared in Fallout 3.

Might eventually 3d print it, need to figure out a drive system that'll fit in it, and a printable chain.

Modeled in Solidworks.

First up was some base sketches.
15035238992_0515bc7480.jpg14849053237_3270ddc57d.jpg

Then the hilt got fleshed out.
15032541131_0254528827_b.jpgripperwip3 by vrogy, on Flickr
15042063392_79111da755_c.jpgripperwip6 by vrogy, on Flickr

Here's the finished model
15021696596_b5c7a9e027_b.jpgripperwip7 by vrogy, on Flickr

Compared to the reference image
14858037089_c120f3b30d_b.jpgripperwip8 by vrogy, on Flickr
 

Attachments

  • 15035238992_0515bc7480.jpg
    15035238992_0515bc7480.jpg
    70.3 KB · Views: 327
  • 14849053237_3270ddc57d.jpg
    14849053237_3270ddc57d.jpg
    45.9 KB · Views: 290
  • 15032541131_0254528827_b.jpg
    15032541131_0254528827_b.jpg
    232.2 KB · Views: 493
  • 15042063392_79111da755_c.jpg
    15042063392_79111da755_c.jpg
    79.3 KB · Views: 269
  • 15021696596_b5c7a9e027_b.jpg
    15021696596_b5c7a9e027_b.jpg
    126.9 KB · Views: 1,898
  • 14858037089_c120f3b30d_b.jpg
    14858037089_c120f3b30d_b.jpg
    334.5 KB · Views: 1,476
Status
Not open for further replies.
Back
Top