Cereal Killl3r
Well-Known Member
Hey Ben,
Been around this forum for just shy of a couple years. I dont often ask too many questions because if you just do some recon around here, you can almost always find the answer to some degree or another. However I havent seen too much info on the "shaping and forming" process when sculpting the outside of a piece. My question is, when you are doing a piece like a helmet where you need both side to be equal to one another... Do you use some type of measuring template or do you just eyeball it?
Been around this forum for just shy of a couple years. I dont often ask too many questions because if you just do some recon around here, you can almost always find the answer to some degree or another. However I havent seen too much info on the "shaping and forming" process when sculpting the outside of a piece. My question is, when you are doing a piece like a helmet where you need both side to be equal to one another... Do you use some type of measuring template or do you just eyeball it?