Hey guys, toom here. For the past 2-3 months, I've been working on a special project.
I used Autodesk Inventor as my modelling software (Its on the computers in the engineering dept. at school) and the entire thing was drawn up and modeled at school.
The images I used as reference, the ones I measured meticulously time and time again, are from veteran prop builder Tactonyx, his work is the sole basis of this, and I thank him greatly.
I'll post files if you want them later, the bell just rang for passing period here at school.
I used Autodesk Inventor as my modelling software (Its on the computers in the engineering dept. at school) and the entire thing was drawn up and modeled at school.
The images I used as reference, the ones I measured meticulously time and time again, are from veteran prop builder Tactonyx, his work is the sole basis of this, and I thank him greatly.
I'll post files if you want them later, the bell just rang for passing period here at school.
Last edited by a moderator: