Paradoxdj Went Shopping + Armor Update

Status
Not open for further replies.

paradoxdj

Well-Known Member
so today i went out to my local hardware store t look at some ribbed hoses that i could cut up to make the side vents on my helmet, i didn't find any at Rona so i thought "well since i'm here..." i went to look at dremel tools and found a good kit for 80$, so i bought it. after that i went to another hardware store and found what i was originally going out for, the ribbed hose.

i also have finished the toe pieces and the H2 hand plates. i am currently working on the cod piece, i have to re glass some spots because the fiberglass didn't bond it the paper right and it was too flimsy.


my dremel tool
Picture33.jpg


it came with a right angle attachment
Picture32.jpg


and 40 bits
Picture31.jpg


and a carrying case, i will need this because my bench is incredibly cluttered
Picture30.jpg




and now for the armor

toe pieces
Picture35.jpg

Picture34.jpg


and the hand plates
Picture36.jpg

Picture37.jpg
 
@BlacRoseImmortal
- yeah i'v used it to cut out the vent holes in the side of my helm and it works amazingly!

i will have the vents in by at least the end of next week, i'm kinda busy working until monday so i'll have to finish it at my dads house next week
 
Status
Not open for further replies.
Back
Top