There's no warping on the helmet anywhere that I see. The table is not even 2 feet high, so I had to bend way down to take the pictures. That's why they're at an angle.
The cold made it dry
really slow, and then it started snowing, that didn't help much either. But I left it outside all day and I just brought it inside and attacked it a little bit with a hair dryer and I think it's good. One piece of advice if you're doing it in the cold, wear a pair of gloves under the latex or nitrile gloves. My fingers nearly froze off, haha.
I'm going to pick up fiberglass cloth (forgot to get some), and I'm going to resin the inside tomorrow morning.
*updates armor status picture*
Yay! Thanks for all the support guys!
One last thing, I'm almost done pepping my torso, but I'm afraid it looks too big. I'll post a picture of me in it when I'm done, but the shoulders are really wide on it. I wonder if it's because I'm a girl and I have slender shoulders. . . no deltoid muscles here
I just wonder if it'll interfere with the shoulders.
Anyway, thanks again!