Pepakura

Status
Not open for further replies.

jebardeors

New Member
I have tried printing out the armor pieces using pepa, however everything is too small by about 2 1/2 inches. any suggestions as to how to increase the graphic size ?
 
is the pep file in landscape? if so did you change your printer settings to landscape? Are you using the correct paper for the file I.E a4/letter?
 
I figured it all out almost right after I posted, thanks for the replies though. Printed and did the high - Def Helmet as a first build took several hours /cry lol now to fiberglass lol





ARMYofONE2469 said:
Pepakura Tut -> http://405th.com/forums/index.php?showtopic=10578



Recalculate parts layout changes size.



than you want to move the piece in the paper lines so it gets printed.



I put my helmets 300mm High, 360mm For Hayabusa.



GOOD LUCK! ;)
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top