Props Halo 3 turret WIP

Status
Not open for further replies.
ok, so here are my plans (please excuse the crude paint drawing)

halo3turretplans.jpg


its mostly all pvc and sheet plastic. ill also be dremeling details into the mail barrel and adding misc items for details
im going out and buying the stuff on thursday
 
i can not wait to see the finished. Results since i am thinking of doing one myself. It would be even cooler if you could make it with the the barrels spinning by putting a motor inside
 
i plan on just fastening the barrels into the main body with gorilla glue, so i dont know how i would make it spin.... but ill try to figure out a way.
 
i have some plans i used for it on .MCX format.. most people cannot use that though.. you might be better off getting a side shot pic of the turret and scaling everything from that.. that is how i did the flamethrower.. it told me the overall length in the halo encyclopedia. a lot of the prints i used were hand sketched since i was pieceing it together and i only had 3 1/2 weeks to finish it.. but anyways ill be watching this build it should be interesting to see what you come up with.. :)
 
Status
Not open for further replies.
Back
Top