Props HDF Halo 3 BR

Status
Not open for further replies.

tazman2087

New Member
I'm making an HDF (High Density Foam) Halo 3 BR. What should I use to coat the foam to harden it. Is it ok to use Bondo?
 
I'm not positive here, but I think bondo and resin melt foam. I've never used HDF so I have no idea but I would imagine they would at least have some effect on it.
 
Will do. I actually did this build flying by the seat of my pants, but I have learned a lot and will def tell you how it goes.
 
Yes resin or bondo will melt the foam, although there are some resins which will not melt the foam. I would suggest brushing it with a few layers of glue and letting that dry after each layer to make it harder to break.
 
Thanks for all the help. I was considering just covering the whole thing in a layer of duct tape. I'll try the smooth cast. I'll post pics asap.
 
For stuff like this, I put on a couple of layers of Galeria Mars Black on the foam before I resin or Bondo it.
 
Status
Not open for further replies.
Back
Top