Noob needs help with an Energy Sword

Status
Not open for further replies.

HotTamale

New Member
Alright, first off, when I say "Noob," I mean I'm new to the site. I have been doing the pepakura, resin, and bondo process for quite some time. I have assembled the handle for the Energy Sword and resined it with a thin layer, but I don't know where to go from there. Anyone know how I would do the blade? I would love to take apart an old toy lightsaber and use the components so it will make sounds and have an activation button, but that's not my main concern.
 
as far as the handle is concerned if you put another layer of resin on there and drill some holes you could probably fill that with expanding foam? For the handle i'd look into plexiglass?
 
Go to the electronics sticky ask ThatDecade this question he will help you out and you can check out his sword as well.
 
Status
Not open for further replies.
Back
Top