Hoping I've made at least a medium-high quality Halo 3 sniper rifle from cardboard, I have made this seemingly daunting project and have decided to at least attempt to become the God Of Cardboard (or at least a deity) enough introduction though, I present my work so far to be critically judged and made better thereof...
The middle of my project in the semi beginning
The whole sniper (a little under 5 feet)
Showing all of my time in some detail
My future plan is to have that flap flip down when you pull back the bolt
http://www.flickr.com/photos/61046704@N04/5559450419/
my mag/clip will have bullets
bland but shows the scope
http://www.flickr.com/photos/61046704@N04/5560028356/
Pulling the bolt back
http://www.flickr.com/photos/61046704@N04/5559448969/
Bonus:sliced mauler (not going to finish probably but the drum spins and the bolt comes back.)
I feel I've done a great job except for conical pieces. I will hopefully resin it and put some type of filler on it (wood filler most likely have used it before)
The middle of my project in the semi beginning
The whole sniper (a little under 5 feet)
Showing all of my time in some detail
My future plan is to have that flap flip down when you pull back the bolt
http://www.flickr.com/photos/61046704@N04/5559450419/
my mag/clip will have bullets
bland but shows the scope
http://www.flickr.com/photos/61046704@N04/5560028356/
Pulling the bolt back
http://www.flickr.com/photos/61046704@N04/5559448969/
Bonus:sliced mauler (not going to finish probably but the drum spins and the bolt comes back.)
I feel I've done a great job except for conical pieces. I will hopefully resin it and put some type of filler on it (wood filler most likely have used it before)