Xtremenoob
Active Member
i made a costume in the past about 2 years ago and it didn't look very good so i decided to do a proper job. My first bit of armor i started was the Mark VI HD chest piece by FLYINGSQUIRL.
once did the back it was phenomenal on how much detail was on the back i just hope it doesn't go away when i put some bondo on it later.
Unfortunately the back was a bit small in my mind so i made a bigger one. So when i put together another back piece and here were the dramatic size differences.
Ill upload the pics once iv finished and fiber-glassed the inside. If your probably wondering since card stock 110 doesn't go through my printer like a hot knife through butter i have to glue normal 80 ply sheets onto the card stock it is a bit of a hassle because the 80 pieces of paper rip up when your sanding.
money is a big hassle but i WILL get it finished.
Unfortunately the back was a bit small in my mind so i made a bigger one. So when i put together another back piece and here were the dramatic size differences.
Ill upload the pics once iv finished and fiber-glassed the inside. If your probably wondering since card stock 110 doesn't go through my printer like a hot knife through butter i have to glue normal 80 ply sheets onto the card stock it is a bit of a hassle because the 80 pieces of paper rip up when your sanding.