Question about molding

Status
Not open for further replies.

blackluc

New Member
I wasn't sure where to post this question, I hope this is the right place.

Last year I made a fiberglass helmet for a friend. The result is great and I am getting requests for casts. I have never molded anything before and I would like to mold that helmet. Maybe I would do it with something else to practise before, but I have some questions. The helmet has a few foam elements on it. Only very decorative parts, such as fake screws. They were heated, glued on the helmet and then painted with spray paint and a clear coat. I am aware molding and foam isn't a good idea... but I was wondering in cases like this if it's possible or if not, what would happen.

Thank you
 
Status
Not open for further replies.
Back
Top