Scaling in Pepakura?

Status
Not open for further replies.

adexder

New Member
Hi guys! I use pepakura for my armor templates and props, but, there's a space marine bolter that I really want to make, but, unfortunately, it's half size. How do I change the scaling in Pepakura so that it's full size? And, how does scaling with numbers work? For example, the bolter's scale is "850".
Thanks in advance!
 
To change the size go to: "2DMenu" - "Change Scale" - Scale Factor"
Down in the bottom right hand side of the designer It'll tell you the pieces current dimensions (HxWxD). Each of these are measured in millimeters, so if you're not familiar with metric you'll need to convert it to inches to make sure piece is to the size you want it. Once you've calculated for any of it's new dimensions (You only need to calculate for one dimension, which I usually pick Height), punch in the new number (in millimeters) and the other dimensions will adjust accordingly. Hope this helps =)
 
Status
Not open for further replies.
Back
Top