Breaking the obj files.

Status
Not open for further replies.

DragonWarrior24

Active Member
Hey there, it's been a while since I last posted anything. I've hit a bit of a road block with my armor-making. mostly stuff with the printer and my job keeping me busy. But I was wondering if I could get help with the obj. files I found here (specifically the legs). I can't seem to un-group the individual pieces to work on. has anyone encountered this problem?
 
Depends on what exactly you're trying to do, and which program you're trying to do it in. Importing the model into Blender and removing everything you don't want, and exporting the parts you do want to keep, is pretty much what you're going to want to do.
 
Depends on what exactly you're trying to do, and which program you're trying to do it in. Importing the model into Blender and removing everything you don't want, and exporting the parts you do want to keep, is pretty much what you're going to want to do.

Well, I'm trying to make the separate pieces of the leg armor 3D printable. And the program I was using was autodesk 123D
 
Status
Not open for further replies.
Back
Top