Help me! Foam Chief Torso Querey

Status
Not open for further replies.

Dox

New Member
Hi all!

I'm in the process of putting together a H4 chief torso, using EVA as the base. Unfortunately, I've run into a bit of an issue with the small centre neck piece at the front (currently on my phone so can't share a photo).

It's the small piece that sits above the second little gap in the armour at the front, that has a little throat protection and some complicated geometry.

I was basically wondering if anyone had any pictures or recommendations on how to go about creating this piece as accurately possible, as foam doesn't have the fidelity but balsa wood doesn't have the flexibility to make the shapes needed.

Thanks in advance!
 
Status
Not open for further replies.
Back
Top