Props Laser cut cortana chip(what do you think?)

Status
Not open for further replies.

kilroyactual117

New Member
Hello all, I recently used a few reference pics to make a rough tool path in adobe illustrator for a laser cut Cortana chip. This is what it ended up looking like:

image.jpg

The reason I made this was because I had a lot of people asking me to 3d print them cortana chips, but I ddint want to take all the time that that required. I might consider selling these here if people show enough interest in them. They're made of acrylic and would cost 4-5$ a piece. Anyway, what do you think?
 
Might be pretty neat if you drew up all of the recessed details and ran a raster pass over them a few times to get some real depth instead of cutting the pieces out separately.
 
Status
Not open for further replies.
Back
Top