Remember...

Status
Not open for further replies.

ChaosDice

New Member
...SAFETY FIRST! Thankfully I was wearing eye protection but I still got my cheek grazed by a piece of the cut off wheel on my Dremel. It shattered while I was trimming down some acrylic for a TacPad screen.

Just a friendly reminder to our Recruits to always practice good safety measures so you don't hurt yourself while building!

Edit: Buy this instead! (Thanks Burt!) http://www.amazon.com/Dremel-545D-545-Diamond-Wheel/dp/B00004UDI9

20151002_223636.jpg
 
An even better tip would be not to use those flimsy death traps.

Fiberglass reinforced wheels are the way to go or invest in one of the carbide wheels.
 
I go through tons of those discs haha. Super flimsy, but they get the job done!
 
I was able to get a canister of 36 for $1 so I was all about it haha! But I went out and bought the diamond wheel afterwards because flying shrapnel is a huge no-no, lol.
 
Status
Not open for further replies.
Back
Top