RvB Meta Helmet (Halo 3 EVA)

Status
Not open for further replies.

JZrex

New Member
Hey guys,

So I just built a halo 3 EVA helmet( pepakura) and got a bit stuck and hoped some of you guys could help me out. I'm not quite sure what to use of a visor on the helmet, since it's such a big area to cover. Any suggestions? Or if you got any tips too that'd be awesome.
 
i know most who make the EVA either get someone to vacuum form it for them or they make a master and vacuum form it themselves or just go out and buy one, i have seen a few cut out eye holes where octagons are and just put plastic behind those and the rest of the visor area is solid
 
I am currently working on an Agent Maine build. I used a pepakura pattern to build my helmet. I did the whole fiberglass bondo process in order to harden it and smooth it out. I cut the visor off the helmet and am going to be Vacuforming it. Vacuforming machines are really cheap to make so I would recommend you go that route. Good luck. :)

My build: http://www.405th.com/showthread.php?t=45493
 
i am currently working on a RvB Caboose build now. nice to see that other people make RvB things to!
 
Status
Not open for further replies.
Back
Top