3D Printed Gold Zeo Ranger Helmet

Status
Not open for further replies.

BillPaxton

New Member
My first print after spending several hours learning and converting Pastel Leaf's pepakura file into an STL. Wanted to show it off, see if anyone was interested in one, or maybe if anyone has any tips to make it better
. Full.png All 4.png P_20150501_153459_HDR.jpg P_20150502_165303.jpg P_20150502_165122.jpg 20150517_101211.jpeg
 
Looking Good!

Only one suggestion.
If you are doing PLA then use UV cure spot putty to fill the print lines ( that is If you want them to go away) then sand.
OR use ABS and get a can of acetone .


Ya know I need a TARDIS . I would totally Zip over there and vac form that for ya in a jiffy so you can preserve the one you have now.
 
Status
Not open for further replies.
Back
Top