- Member DIN
- S386
Re: Noble halo5 3D printing armor for a client
OK the chest front is done! .. I did tack glueed the upper 2 parts.
the whole chest cadge is SO rigid that It nees to be built to fit the rest of it's self so by declareing the back as the origin point I can tweak a few joint lines to make it look just right and then lock it in place.
Ill have pics in a hour or so.. paint needs to dry..
dang! that dried fast!
Pre paint right after acetone wash.
Painted 1st layer
PeterD
OK the chest front is done! .. I did tack glueed the upper 2 parts.
the whole chest cadge is SO rigid that It nees to be built to fit the rest of it's self so by declareing the back as the origin point I can tweak a few joint lines to make it look just right and then lock it in place.
Ill have pics in a hour or so.. paint needs to dry..
dang! that dried fast!
Pre paint right after acetone wash.
Painted 1st layer
PeterD