Hey! i haven't been active on this project for a while, and i apologize for that... however, I am back at it now! ive been pretty busy with school lately so it's been difficult to get time to work on this project. I've printed the lower back section of the helmet and it looks great! the visor...
Those tutorials are gold! Thanks a lot. Once i finish writing the code for the shield bar, i will post instructions on how you can do the same right here!
I decided to form the visor, and it looks pretty good. It is still completely clear though, so thats pretty bad. The helmet itself is going to have some internal electronics that will make it stand out. There will be a shield bar at the top of the users field of view. and will raise and lower...
Hey, I'm pretty new to this site and stumbled upon it while researching good Halo props and stuff. I am making a Helljumper Helmet (basically an ODST helmet for Spartans). I am 3D printing the base of the helmet, and I am not sure what to do for the visor. I have some high-quality sheets of...