Recent content by Hyena

I believe it was nintendude who had the files for this. For Jin-roh, or one of the two live action movies that gave birth to the panzer cops.

Has anyone made or found an unfolded pipboy 3000 from fallout 3, or any of the other variants of the pipboy? I used the search on this site, as well as google and have thus far only found folded models for pepakura. Looking for the pepakura files, unfolded.

Have you done any more work on the BOS armor? This is an amazing show of skill. Once i have completed my ODST build, i will begin working of BOS armor, and your thread is my major sourc of encouragement to keep going after all the annoyances of pepakura.

Its a lot better then my failed attempt. Good work

I tried a different brand of super glue, four tubes for one dollar. But this glue is horrible. It takes almost a minuete to dry and is incredibly runny. Its almost like water, just gets every where. I have the torso built now. And i have resined the outer side of it twice and...

http://www.405th.com/showthread.php/21739-Fallout-3-Terminator-Wip./page4 i think the third post down, link to shoulders on 4shared

My request is that some one make pep file for the fallout 3 t-45d brotherhood of steel shoulder armor... much gratitude to the one that does

i picked up a quart of 3m brand (I thought 3m made bondo, but if they did, whats the point in having a product thats the same under just the 3m logo?) fiberglass resin. I am going to try it and see if there is a difference in the end result. Part of my goal with this, my first project, is to...

considering you are more then likely to be more experienced then i am you are most probably correct, but for me i found the thinner material (the matting) to be easier to get in the rite size and shape i needed so it would fit in all the tight spaces.

vacuum forming (use the search option to find info on it) is the best way to get the shape. As for the skull design, as far as i know, the best method for that is to trace it onto the visor and then use a craft knife and a few fine grade files and clay modeling tools. On the website...

After i get some more practice with pep, i'll be all for this. mad props to all who have worked on this. The modellers, unfolders, and those who have built it.

I would give my gratitude to anyone who posts up the shoulder pads... i am setting up to build the t-45 armor after i finish my ODST project

You could always check for a local Amtgard group. After the SCA, second largest LARP in the world. They have groups as far out as Germany and Australia. Somewhere oline, there is an amtgard atlas, though it does not get updated often, it will show you the location of the groups in the u.s. also...

fiberglass resin is needed. If you buy bondo brand it comes with hardener. You should also get fiberglass matting or cloth. The looks prettier, but from my experience i have found that the matting works better for this type of project. I would go with standard body filler.

i currently lack the room for a vacuum table, otherwise i'd be all over that like white on rice. At least with the small pieces i have resined thus far i have noticed no warping. I did get some warpage from superglue in the initial build stage, but none from the resin.