Recent content by ionHighlander

  1. I

    Scout build

    It's finished!! My scout helmet is finally finished. It’s been a wail sense I have updated my tread, haven’t had much time now that school has started. Recently I finished the last few detail lines with some modeling paint. I am surprised how it turned out; it looks really good, especially for...
  2. I

    Props Focus rifle build (Satchmo III)

    Awesome work bro.
  3. I

    Scout build

    No changes have been made
  4. I

    Scout build

    Over the past week, with school starting and all, I haven’t had very much time to work on my helmet. I did manage to finish all of the padding though. There is not too much to do any more, just a few yellow detail strips and then it will be finished. I already started a mrk V (a), but all i had...
  5. I

    Scout build

    past several days In the past few days I did a lot of work. I finished all the electronics (fans, leds), I think the wiring is one of the cleaner jobs I seen. I even though of covering the leds on the inside with some wiring tape so you can't see my face when they are on. The visor is mounted...
  6. I

    Scout build

    Over the past several days i accomplished a lot of tasks. So far i cut out the visor, still working on a way to mount it though and still have to cut the detail lines into it. The lights are ready to be installed with the fogged lensed, cut out of Lexan plastic, and fogged with a wire brush in...
  7. I

    Scout build

    Week three of my scout build This week has been a very busy week around the house. I haven’t had much time to work on it. Final sandy is just about finished still. There are still a few places i need to touch up though. This week i did get the lenses for the leds cut, I am not going to install...
  8. I

    Scout build

    Second week of work So far this week I almost have all of the bondo done. There are just a few spots I need to touch up with some spot putty. Currently I am in the stages of final sanding with 120 and 220 grit sand paper. After finishing sanding, I plan to start fitting the visor. After that I...
  9. I

    Scout build

    It does not matter what side the filters are on as long as they are fully sealed, and the small side of the filter is facing forward.
  10. I

    Scout build

    After finishing the JFO build with Satchmo III, I have start building a scout helmet. During the last week I have finished the Pepakura model, the first inner coat of rondo and 2 layers of fiber glass. Currently I am working on the outer final bondo layer and the hardest process of sanding. It's...
  11. I

    JFO helmet build work-log (Satchmo III)

    I am Satchmo III's brother. We thank you for all you input and feedback.
See more
Back
Top