does anyone have or plan on making and unfolding the boots,shoulder pads and gauntlets for the onyx guard i have the helmet and chest but need the rest to finish. please let me know thanks.
GOW 3 Fenix armor
does anyone have marcus fenix armor .pdo files from gears 3 i have his old armor but want to build the new armor if anyone has them please help me out. thanks
i attached it with a peace of 3" wide nylon strap and pop rivets
here is a pic of my belt that i did the same way because i cut i into six parts and had to re attach them
the only thing differnt is on the baird armor i ran the strap up and down rather then side ways like in pic
that way you...
Yes i used 3/4" thick black foam my friend gets it from his work for me
I used a hot glue gun to put on all outside panels then drilled holes threw then used pop rivets not screws.
I used nylon strap on shoulder just cut out a little spot and used small washers and pop rivets
here is a...
what might work is sanding it as smooth as posable then dont't weary about sanding through paper then resin over it maybe two layers i have done that on my helmets and it seems to come out smoother each layer if you build it up and sand it smooth you might be able to get away without bondoing
can any one please make and unfold the marcus fenix armor from gears of war 3 it doesn't have to be hd just low detail I have seen the anya and carmine and onyx guard armor but no marcus please i have pics if you need them
I can get more if you need them.
i put 2 layers of just fiberglass resin on outside and one on the inside then put another layer on the inside but used resin and fiberglass cloth then sanded it. then a layer of bondo its good to prime it between bondo layers after sanded it makes it easy to see were you need more bondo. then...
I used Craft foam sheets for the armor plates you can get them at most craft stores and used 1mm 3mm 5mm thick. and used 3/4" maple board for the two black chest disc i cut them out then routed a 45 edge on them on a table router or if you can find a black speaker cover about the right size. and...
I cut out the inner collar and glued in a black foam one. my head just fits through do not split it in two parts it will not look right i cut out the bottom just enough to squeez my shoulders through.
if you still can't get it on cut one of the sides out so you can slide it on then reattach...