Recent content by mark

well if you read the books you would know it would be accesable by chin

well this stuff could be used when done with the fiberglass part as glass tends to stink so i guess covering up the glass oas the last layer will be smother looking on the inside as well as a no smell helmet and could you use this stuff in replacement of body filler for detailing?

i think a layer of glass can stand up to the same stuff that a sheet of balsa wood can withstand

yeah and pricing

umm the cutscenes and the trailers his visor is reflective but during game its just a texture

well what i meant was extracting the model for pepakura

has any one thought of using the model used for the xbox 360 game dead or alive 4: spartan 458 nicole?

well you can use spot putty like i did for my helmet

because trying to clean up fiberglass off a visor wouldnt work too well and it should be the very last thing you do (after electronics and padding)

the visor is like the last thing done

well the smg only loads from the side because its caseless as in it has no copper shell (I'm only speculating what it means) and for the carbine it ejects the cartridge when it runs out of ammo

well you COULD fiberglass the visor in the PROBLEM is keeping it clean during the process

well the pep files are straight from the halo 2 game so the modelers at bungie made it

an x acto knife i find to be easier to cut with but hey

ok what i would like to do is start a thread showing or describing places on the armor where you can put a cooling fan in without putting random holes in the armor