Recent content by MoeSizzlac

Note: something is going on with thingiverse right now. hope this loads Updating for Halo 4 Recruit Helmet: Halo 4 - Recruit Helmet by moesizzlac

Updating for Halo Infinite Cambion Helmet and Februus Visor: Halo Infinite - Cambion Helmet and Februus Visor by moesizzlac And finally, a basic visor:

Updating for the Halo Infinite Gravity Axe - Diminisher of Hope https://www.thingiverse.com/thing:6561325 You may also need the following additional items to complete your build: 1) 2" Wooden Dowel...

Here's the Halo Reach CQC Shoulder scaled to the smaller size one. Print it at about 130% for the larger sized one. I'll let you figure out which way is up ;) https://www.thingiverse.com/download:14212885

Updating for Halo Infinite Stalker Rifle. May I never need to touch this guy again. https://www.thingiverse.com/thing:6489322

Updating for Reach Operator Helmet with and w/o B5D0 Optics: Halo Reach - Operator Helmet with and w/o B5D0 Optics by moesizzlac - Thingiverse

Updating for the HAZMAT Core armor from Halo Infinite: Halo Infinite HAZMAT Core Suit by moesizzlac - Thingiverse

Updating for the entire Halo TV Series Season 1 Silver Team Armor set: Halo Infinite/Live TV Series Armor - Silver Team Vannak, Kai, Riz, and Master Chief by moesizzlac - Thingiverse

Working on that next. There is a lot of fabric in that one so the hard parts are going to be smaller than a usual set.

Updating for Halo Infinite Security Helmet: Halo Infinite - Security Helmet by moesizzlac

Updating for Halo Infinite Deadeye Helmet...with cat ears https://www.thingiverse.com/thing:6389155

Updating for Fred 104: Halo 5 - Fred 104 - Concept Helmet based off of Kory Lynn Hubbell Sketch by moesizzlac Model is based off a sketch from Kory Lynn Hubbell found here: https://www.artstation.com/artwork/VbdbN

And it's Finished. I was able to simulate a clean print with simplify. This was a tough one for me. Updating for Halo 4 - Enforcer Helmet: Halo 4 - Enforcer Helmet by moesizzlac Whomever made the original here was a mad lad I'll give them that:

I'll be lucky if this thing works in simplify3D/cura. Still have to do the back and top.