Recent content by MosquitoBandito

  1. MosquitoBandito

    Props Halo ODST helmet and armor

    Here's the before and after of my Sean Bradley odst helmet. Forgot to make posts as I went along, but I was just so excited to get it done! Includes a flashlight and two working LEDS on the sides of the helmet. Visit my instagram to see vids of the helmet as well. Visor provided by...
  2. MosquitoBandito

    1st Build My newest project

    Thanks a ton! Excited to finish it!!!
  3. MosquitoBandito

    1st Build My newest project

    Update: The butt armor and belly button armor are done. All that's left for printing are the legs.
  4. MosquitoBandito

    1st Build My newest project

    Another update, printing of the upper half of the armor set completed!
  5. MosquitoBandito

    1st Build My newest project

    That would be the mk6 gen 2 from Halo 5
  6. MosquitoBandito

    1st Build My newest project

    Here's a progress update to my newest build, this is all the armor I have printed so far (minus the right gauntlet and hand armor)
  7. MosquitoBandito

    Props Mk 6 arm pieces

    Ikr, this armor is gonna be so bulky it's gonna be so sick
  8. MosquitoBandito

    Props Mk 6 arm pieces

    Finished printing the left shoulder piece after fixing up my printer. Currently making the right shoulder as well, then once that's done I'll have the upper torso completed, where I can then begin printing the lower sections of the armor. Better photos and vids on my insta!!
  9. MosquitoBandito

    [FIRST BUILD] Mark VI(Gen 2-Halo 5) Pep Build (Moderate Pictures(?))

    I'm working on a mk6 gen 2 as well, is there any way that I would be able to get ahold of your pepakura files??? Or where I might be able to find some??
  10. MosquitoBandito

    3D printer HELP thread

    Yes it retracts and yes it does have the QR code, but it just brings you to some links (two of which are like coding and wiring stuff that I know nothing about) and the other one just brings you back to the antclabs home page. The probe I got was the official one so there shouldn't be any...
  11. MosquitoBandito

    3D printer HELP thread

    I bought it on Amazon, but as far as I can tell it's the same one, there's nothing else on the listing that says anything about active high or low or anything like that. I did take out the pin and hit the level button to see what It did, and it just did the same thing. Nothing changes whether it...
  12. MosquitoBandito

    3D printer HELP thread

    Yeah I dunno, it doesn't even get close enough to the bed in order for the sensor to touch, I dunno how else it would be triggering it. Altho you might be on to something, this problem did start after I replaced the probe.
  13. MosquitoBandito

    3D printer HELP thread

    When I hit the leveling button, it automatically goes to home, but it doesn't lower. Then it goes to the center of the bed, and then just raises up.
Top