he could just put his finger under it when it lifts up. :D
or maybe when it lifts up it hits a switch which kills the juice to the laser. i dunno. im not being entirely serious anyhow. :)
im sure it can be done but I couldnt tell you how. unless you just replaced the blade on a silhouette sd with a laser. that would be the easiest way i would think to do it. :D
Mine does not cut all the way through. I notice that it seems like it cuts best on upward strokes vs downward ones. Cut it twice and they pretty well fall out.
But still way nicer than manually cutting.
does the bondo stick to the plastic well? or did you scuff it up real good prior?
i bought this nerf gun today.
does yours still shoot the nerf darts? if so worse or better than before?
odd issue. if i am using designer and save the file with edge id's on it will not print in viewer for robo.
in fact it just prints rows and rows of black ink which my wife loves. :D
but if i turn them off in viewer, save the file, turn edge ids on print its fine. odd.
what did you use for the barrel?
I was just looking for a nerf gun to convert into a halo gun.
other than the barrel the rest was just cosmetic changes, correct?
go online and look up pre-wired LED's, radioshack sells some pre-wired ones. Obviously they are prewired with a resistor to make it alot easier.
nothing is going to be fantastic for real night use if your just using a 9v battery etc.
glad you got yours going as well. i find i still need to cut it twice for cardstock. wondering if changing the speed setting would help? (probably needs a new blade?)
The most frustrating thing is getting all the software going etc. if you can install it all before you get the product it will go...