Recent content by scorch

NobleofDeath16 Spidermonkey60 Confirming that I am coming. So looking forward to this!!!!

Finished.

I completed my neck seal an added some details to most of these pieces that were missing. I also re-did my little ab wrap to make the foam parts bigger. This will make the lower back not as bare. All I have to do technically is put one magnet on my visor but I think that is pretty much it for me...

I tried that for this one = ( didn't seem to help. Was pretty hot outside too. Not sure if I would try this again but I am stubborn. Thank you for the suggestion though.

I wanted to try to do a difficult part on the bicep that I omitted for 'practice'. This was how they were constructed and I tried to combine pieces. I also added another thin layer of foam on the back side that wasn't there. Tried sealing this with leak seal and it came out textured. Leak...

I added a thicker wing to the belt for around the waist. I pulled off the old one, assembled the new one, and glued it on.

I am so exhausted. My fatigue betrays my love for this. Either that or I am seriously trying to suppress some existential dread. The little console thingy is added, along with the knife and the sheath. I had to reinforce some areas because there was some tearing. Also whatever that smaller...

I remember you from that one night on MCC! Thank you very much! That means a lot.

Here is where it is at. Still have to add a few small things around the neck, that little console below the chest, spartan ability, and customize the gun with some colors. The knife and sheath is drying so I will attach that on as well.

Thank you I am going to try it all on and post some stuff. Need someone to help me put it all on. I can only do all of the lower, or the upper body with only one arm equipped. :lol: I appreciate the support.

Man time is flying. I can't believe it has been a month. Made some parts to cover some joint areas that looked bare. Worked on some gloves. Added some air brush to the wrist parts.

Thanks for the feedback and tips. I liked how it was coming out too initially. I will take it it slow on the blackwashing part . Thank you ZettaiKagerou!

Here is what is what I was able to do this time around. I painted some new pieces I made black first (ty PlanetAlexander ), then with slate. Everything else that was not remade, I merely coated with slate again. After that I tried my hand at airbrushing with a cheap air brush kit. I had a...

I thought I updated this but apparently I didn't. Long story short - I painted everything and didn't go so well because I was following the action figure I have from the Reach era. Lo and behold the action figure is not represented consistently online, nor is it comparable to the game model...

Whoops! Okay that's good to know for 'next time' though I'm promising I'm not doing anything over