Recent content by shadows0fintent

for those who do not know how its going to be made, i have made a drawing of the constructed gun, you nthen have to imagine the thickness for yourself but each piece is numbered so you know where it goes.

thanks for that, i have been using a 1 calorie cooking spray, i spray it on and then with a soft brush make sure it goes into all the gaps and makes an even film, then i let the excess dry and cast. it works on urethane rubber and it helped the silicone separate from the foam. all i need to know...

hi, i started making this pistol for a friend of mine at college who wanted one to put on a stand. i started by making an smg which was cut out of foam board very well, only problem was that the rubber i used was almost empty and there was not enough to cover it and so it failed miserably. i...

well i have started out making a frigate. its a scratch build at about 3 feet long. its half a cm thick but when layered it will be the full 3d thing. its no where near completion as i have other projects at the moment including an odst pistol and smg along with a gears of war lancer rifle.

well the point of it being flat was that i can add lots of detail and that it looks better on a wall. with it coming out of the plaque, 1 it would be difficult to construct and 2 you would not know where to put it on a wall. also the good thing about this is if it works then i can make a...

well im copying this one, i have the book so i can scale it up from that. i have also cut it in 2 to show what i am doing for this one, because i will be making moulds of the slices then theoretically i could make the whole ship in 3D but a bit later in the future

i thought it looked a lot like the lancer from gears of war, just add a chainsaw, some details and its very near. plus on the box the top left image looks like the hammer of dawn as well

just so you can see where this is heading here is a small sketch of the outline of the ship, its slightly different to the one i'm doing as mine is from the halo art book and this is from the orbital level in halo 3

thanks for your reply, i was thinking that no one was going to bother with it, anyway here is a photo of waht i have done, it looks a bit out of proportion as it was free handedly drawn. what i wanted to do was to make the main structure or centre of it into 1 huge piece and then make a...

well i was bored at work today so i had a look through the art of halo 3 book and saw the image of the ship UNSC Andraste, i imediately thought that it looked cool, for those who have the book its on page 37. so at the moment i am making the main inner body of it, this is the main structure...

its not a pep build, its home mae, but you can find the peps on this site somewhere. update, foamboard can melt, well the binding glue can at least. i have cast the stock of the gun, 2 magazines, the front handle, and some little bits, i am preparing the other parts to be moulded soon, i will...

nice gun, just sene your odst smg and sent a pm, are you making cast kits of this gun as well as if so i am very interested

i have had a few private messages asking about the moulding of the gun, heres how its gone so far... the mag has been done and after a failed attempt has been finished and is ready to use. the front handle was tried out this morning but due to a different type of foam board it did not...

most people don't want to waste money on expensive brands like smooth on or smoothcast, thats pretty much what you pay for. you can get the same quality produsts elsewhere for cheaper if you know where to look, each time someone says look at the stickies i go to them and they never have what i...

i am currently using stuff called gelflex, its a silicon like moulding material which you chop up and melt, once liquid you pour it over an object and wait to set, it sets and holds the imprint of the master so you can cast from it. the best thing is that if you don't want it any more or its...