Recent content by shadowspart

I'm thinking about vac forming it, but I may just attempt doing it with layered visors. It's going to be tricky at any rate!

Hi all, I broke out my Security build again to hopefully finish it once and for all. I have a few pieces on the pep to add but I've almost done that, I am slightly worried about some of the gaps. PICS The glue is a bit messy, but it does seem to be strong.

Dude, your Bondo work is so clean! This project looks amazing so far, I can't wait to see it finished!

Hi, I have been making a Halo Reach Security helmet, and I have come across a problem with the visor. I need to use a bubble visor for the main shape but then I need to create the two notches at the top and bottom. I could do a double layer style visor but I would prefer to vacuum form it. Is...

Nice work on the joints of the build. The welds are so neat!

Ahh I saw that convention when i was looking at cons in the area. maybe ill see you there

Which con is it? ill try to get there with my armor when i finish it.

I'm moving there beginning of august and want to know if anyone is there who I can build with

Gonna Bring this Thread back to life but not til around August because I'm emigrating To the U.S

The second helmet is much better than the first one! I dont mean to say that the first one was bad but i like the second one better.

Wow your pep is really neat! I like the Armour choices.

Thanks for the explanation.

Wow you have done loads good work and keep it up!

Nice work! Gonna keep an eye on this thread.

how would you sheet tint a curved visor? could you heat shrink it?:confused