Recent content by Toftt Nightmare

Thanks a lot.

I read over the sticky and still have a question with the mix process. Do you mix the paste hardner into the bondo, and the liguid hardner to the resin, and then stir the 2 together? In the sticky it says to add 2x liguid hardner, I'm guessing that means you just mix the resin and bondo...

You're doing an outstanding job man, keep it up you can get this done by launch! You and Acenat are going to look badass side by side, can't wait to see some more pictures.

Your so close! DC's FTW!

Excellent Tut! I'm having trouble finding a belt and suspenders, the first link on your thread still works and It looks like I can find the webbing,buckles,and screws from there but if you could help me with the rest that would be awesome. Thanks.

Your new progress is killer as always, I think the chest piece looks fine, is there a file for the lower plate of the chest thats in the pic harican posted above? That would def help you add length, Either way it will look awesome.

Your armor looks great, and you built it in such a short time! I have a question about the chest piece, it looks like you used the HD model by flyingsquirel and I'm about half way done with it. Did you put the entire chest together (with the support struts)? I'm not sure if it would be best to...

I've done some searching with no luck, if anybody has Flyingsquirels tester for the high detail chest piece build that would be awesome. I have his HD chest piece, but not the tester. My email is peterfrancus@hotmail.com Or if you have a link to it that works to. Thanks a lot!

Thanks again, I looked a little for it but had no luck, I'll look more after I get off work later tonight. If I can't find it I'll just cross my fingers and build the HD model haha so far I've gotten lucky with Xtreme Tactics scale method.

Here is Supertaco's testers dimensions H-508 W-457 D-460 And then Flyingsquirels dimensions H-508 W-474 D-485 I wonder if I did something wrong.. I'm just plugging the same scale # I came up with into both pieces... Thanks.

Thanks Ral. I was about to print supertaco's tester chest piece, however I notice when I plug in the height the width and depth are slightly smaller than flyingsquirls hd chest piece. Any advice?

Thanks for the quick reply, and for unfolding the hd forearm pieces, they turned out great. I have the tester chest piece but noticed the numbers are missing so I'm not sure if I want to try to assemble it or not even though it does look pretty basic and is probably the smartest move.. I'd hate...

I am useing Flyingsquirels HD Chest Piece model, however I noticed the default height of it is set at 403mm. My question is after I scale it it's telling me the height should be 508mm, which is way bigger than the original file. Does anybody know if this chest piece is set to the chiefs height...

Well it's been a very long time since I have been on the forums, glad to see they are still growing. I made a very basic set of armor in a little over a month for the launch of Halo 3 and once again last minute I'm going for a new set of armor. I just finished up the High Detail forearm, it took...

Here is my armor from right before Halo 3's launch.. It's with the Halo 2 pep files.. I cant remember which version though.