Recent content by ZakuAce

Very Cool, can only hope my Gundam comes out this nice!

I haven't updated this in a while, but the bondo work has been going pretty well, just about done with it (i hope). I will post some pics later this week (today or tomorrow) and then I will be off to finsih sanding out the inside (once I get some replacement sanding pads for my dremel) and...

Man, this thread has exploded in the last few weeks. Anyway, I finally had a few minutes to finish the foot unfold, so I am pretty sure the RX-79[G] is complete. Here is a link with all of the files. Most of the models were cleaned up and provided by Blertz as well as some of the unfolds. I did...

here is all of the sinanju files, fair warning, these are a little rough, some of the files have breaks where you will have to connect them to the other part of the piece with your own tabs spliced in, but they are pretty detailed. Hope it helps. edit...

I could see it. If you build a costume scaling will inevitably be screwed up. Human proportions and gundam proportions just don't mix. So if you want a realistically scaled statue it likely couldn't double as a costume, unless you were to drop a whole lot of extra time into engineering the...

Cool stuff Blertz, thanks. @ SabrX if you can't find the the NT1 files on 405th, i think they are in the beginning of this thread, but I have the full set somewhere on my computer, I can reupload them if needed. Also, I am working on the feet for the RX-79[G], this model is quite a bit messy...

Looking good Blertz, you are making it really hard for me to want to finish the RX-79[G] build (since I am no that far). EZ8 was always one of my favorites and those pep files look amazing. May I ask what 3d ripper program you are using? I tried to get that to work once but didn't have any luck.

@SabrX : I have seen those same files, really good quality stuff, too bad they are locked. I haven't been able to track down an unlocked version yet. In other news, here is the unfold for the RX-79[G] Shin. http://www.4shared.com/file/pMQcKktX/Ground_Gundam_Shin.html

And here is the thigh http://www.4shared.com/file/wjc4IyZq/Ground_Gundam_Thigh.html

forearm done: http://www.4shared.com/file/fJezjPRA/Ground_Gundam_Forearm.html btw, if people haven't noticed, I am doing these on legal sized paper (8.5x14) You can get legal sized cardstock off of amazon, i recommended it if your printer can do it, saves sheets and allows for less pieces...

Starting on the Bicep unfold edit: done http://www.4shared.com/file/6hJ0aKzi/Ground_Gundam_Bicept.html I will start the forearm next

if you post i can help with the unfolding

Gundam RX-79[G] files that's what. Thanks to Blertz we are getting pretty damn close to finishing them. Based on the unfolds i have on file, we are missing the arms, legs and feet, that's it.

Yes, Blertz and I have been working on the RX79[G] files for a while, most (if not all) of the files we have done should be in this thread edit: also digging your RX-78

Awesome BlertZ, thanks. Here are some that I unfolded Codpiece: http://www.4shared.com/file/B7BGH8Cr/Ground_Gudam_CodPiece.html ButtPlate: http://www.4shared.com/file/PDx0B_X_/Ground_Gudam_Butt_Plate.html Thigh Plate: http://www.4shared.com/file/xfdZZ4Xv/Ground_Gudam_Thigh_Plates.html Hip...