leds

  1. Zachary

    Props 3D Printed Brute Plasma Riffle

    Hi everyone! in this thread i will cover the assembly, electronics, finishing and painting of a 3D printed Plasma riffle kit from rogue workshop. this project was steched out over almost 2 years (the project itself being shleved for 1.5 years. due to this, some documentation is missing and i...
  2. StorakTheVast

    Adding lights to shine through chipped paint

    This video shows how to get a 2 in 1 chipping and lighting effect to make your suit stand out in a crowd. I used a resin print; however, I assume you can get the same effect with translucent filaments. The part in the video is the right shoulder of my "Broken by the Banished" Mark IV armor set...
  3. Shadow the ODST

    odst helmet visor lights advice

    My ODST helmet is almost finished but i am planning on adding lights to the visor to recrate how the in game helmet can change between tinting and see through. I have tested the visor and light will cause my black tinted visor to go clear but i am not sure how to set up these lights. Should I...
  4. RandomRanger

    Ranger's Wiring Guide

    This guide is written for people who aren’t overly familiar with electronic stuff but still want to produce a high quality product. Supplies For all the supplies, there are many products that will work just as good, but I’ll link the ones I used for simplicity. Resistors (only need 120 ohm)...
Top