resin

I'm at the point I need to resin parts and round edges more. I'm going to work on some parts I made before but turned out to be larger then I need them to be. Anything I should know or try when doing test runs? What should I look out for? How can I round the edges and stay true to shape?

*PIC HEAVY* My first step was to use the pepakura files from the Armoury to build the base helmet using 5mm foam. I also built the Elite head pep to make sure the two fit together I pinned on some strips to make sure it held the right shape before slushing some plaster on the inside. This...

Hi there, Im lookjng into posible ways of toughening up my armour prior to painting. Its a ironman endgame model. To help woth details i broke each component down into 3 layers. Outerlayer - these are the plates of armour over areas that wont need to flex. Base layer- these are the areas in...

I've probably watcher Cereal Kill3r's videos a thousand times over and I've decided to go with Epoxy Laminating resin. My question is: Is this stuff good enough? It seems cheap for epoxy. {{model.productMeta.WebStoreDisplayName}} If it isn't, what are my alternatives? Unfortunately I'm not...

Hello everyone. I've been searching around for alternatives to the typically fiberglass Resin/bondo stuff and stumbled across a Non-Toxic brand of Epoxy Resin known as: ArtResin ( Clear Epoxy Resin Kits - ArtResin ). I've been thinking on trying some out on my pep helmets but wonder if any of...