Reply to thread

thanks Rundown, I finally got them all fixed (I think), I got rid of them by adding more edges to the "flat" surfaces, I wish there was a way to make them show up in 3ds max. I'd fix a few, then save & export, re-open in pepakura, and look for more... talk about a pain in my a$$. but it was a good learning experience for me


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top