Reply to thread

Helmet came out great! scaling looks good too! I've found that if there's issues with the start of the print and bed adhesion, I use Rafts instead of the brim (it eats up more filament and takes longer because I had to slow down the speed for the first few layers, but my adhesion errors have gone down dramatically).


This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top