Reply to thread

Message

Ah, to have a printer that can do a helmet in one go... I started with an Ender 3, splitting up those same files, and I broke down and bought a bigger printer. Lol, It's so nice! Well done with the first couple prints! I finished my first set in Oct., and I was finding I had to do at least 3 heavy filler primer coats, but I was also printing at .2mm layer height. What are you printing at? Like others have said, sizing looks great, better to have a bit too much room than a bit too little, like mine. Keep up the great work!

[QUOTE="Ulfhedinn073, post: 836346, member: 52766"] Ah, to have a printer that can do a helmet in one go... I started with an Ender 3, splitting up those same files, and I broke down and bought a bigger printer. Lol, It's so nice! Well done with the first couple prints! I finished my first set in Oct., and I was finding I had to do at least 3 heavy filler primer coats, but I was also printing at .2mm layer height. What are you printing at? Like others have said, sizing looks great, better to have a bit too much room than a bit too little, like mine. Keep up the great work! [/QUOTE]

This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification