Reply to thread

I'm gonna be real honest, I'm not sure yet- I think I'll figure that out once I see how easy or hard it is to get on and off when it's all printed and I can tape everything in place to see how it fits. I have a feeling I'll be using magnets, but I'd rather see if I could manage to slide it on and off lol


This thread is more than 12 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top