About to rip my hair out can some one help?

Status
Not open for further replies.

Card

New Member
Okay here is my problem I have been building a set of armor and till now the problem has not come up. When I try to re size my armor pieces there are parts that are just too big to fit on one page. I don't exactly know how to fix this any help would be great
 
If your using designer (not sure if its the same in the viewer) there is a button the third from the left called "Divide/Connect Faces Ctrl-N". Use this button to separate the larger pieces so that you can place them on separate pages as needed.
 
Settings > Print & Paper Settings > Tick "Print alignment marks for multiple pages". This will allow you to line up larger pieces, and rejoin those pieces. They will however have no tab, so just glue a strip or scrap card across the join. Particularly useful for long pieces (like rifle barrels).
 
Thank you so much this will help for the Chest and other parts that have longer pieces *Bows.* It is very much appreciated!
 
Status
Not open for further replies.
Back
Top