Reply to thread

I just reprinted the chestplate because the old one was unusable, now the alignment it screwed up... Should I reprint the backpiece or try to bend the chestpiece into position? I assume due to the backpiece breaking apart once and by glueing it back together it created some weird shape issues, leading to this very, very bad alignment error. Again, what should I do? Reprint or bend?

[ATTACH=full]352111[/ATTACH]


This thread is more than 9 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top