Articulating helmet visor tutorial - no electronics involved


You just need a visor, some hot glue and two teeny tiny screws for this manual articulating visor!

Ideally the screws wouldn’t be visible on the outside, but my visor wasn’t quite long enough to accommodate, v2 will be better!

I have built a circuit to automate this with a mini microcontroller, but here is an electronic-free way to open that visor! I’ll post a separate overview for the electronic version and include a circuit diagram and info on the components purchased to make it work.


This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.