Reply to thread

Update 3/13/24


After attempting to print my first forearm of the build, my printer decided to give me some troubles.. I narrowed it down at first to a cleaning issue and gave it some TCL. After cleaning it out as good as I could at 1 am, I gave in to my need to start it back up asap and put a new nozzle in the hotend. After tightening it back up and giving it one last look I noticed that the nozzle looked a little crooked.. turns out the hotend block was a little more dirty then I thought, and it had cooled down before I tried putting in the new nozzle. Since I tightened the nozzle with the strength of Thor I ended up cross threading the block..

[ATTACH=full]344107[/ATTACH][ATTACH=full]344108[/ATTACH]


After some Amazon review reading and figuring out how to disassemble the hotend. I found a part to replace the block and ordered it! (Also ordered and upgrade for my CR-10s that I will try and also use for this project) After waiting hopelessly for 2 days I finally got my part and was ready to install! After getting my tools ready once again and opening the part.. I tried installing it when I ran into a problem.. my thermistor didnt work with this block..


Now I sit and wait hopelessly once again for a new hotend assembly since I could not find the correct block..


Im sorry brother.. my homework will be a little late but ill have it fixed in no time!


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top