Carter helm unfolded by BMcClain question...

Status
Not open for further replies.

77th Hornet

New Member
Howdy folks, new to the site here, and to the world of armour creation. I'm cutting out the back pieces for Carter's helm, and if anyone else has the same file, there's a tiny little valley fold on either side of the biggest piece, I hope this describes the spot well enough... I was just wondering what the best way to go about those specific tabs would be, as they are less than a 16th of an inch wide. Any help would be greatly appreciated. Thanks folks!
 
Are you sure you didn't over size the pep? The rest of the tab might be on another page. If those aren't the case (I haven't seen the file), I'm not sure what to say.

Just be careful I suppose? (you might also use a ruler or something)
 
Status
Not open for further replies.
Back
Top