tahu505

Active Member
So the current rolls of PLA+ I have don't have enough filament in them for the armor pieces I was going to make so instead here's a new small side project! Halo CE magnum that I'm going to paint chrome gold inspired by the gold magnum skin in MCC CE multiplayer!

I'm going to be 3D printing the M6D model made by CollinMcCaf and have so far printed out the receiver. I've also scaled each part down by 10% just so it can fit better on my Ender 3 and to not cut the material usage too close for my spools.

20210327_153752.jpg


20210327_153827.jpg
 

Dire

Sr Member
I haven't really seen a 3d print look rounded and ergonomic, either you have a helluva 3d printer or you sanded like crazy
 

tahu505

Active Member
I haven't really seen a 3d print look rounded and ergonomic, either you have a helluva 3d printer or you sanded like crazy
Thank you! My printer is an Ender 3, one of the more basic 3D printers. I did a good amount of sanding but it didn't really take too long. I was using PLA+ so it was really easy to sand.
 

SI3RRA 117

Well-Known Member
I dig it (y). But to properly show that nice piece off, we need some photos that don’t have the pistol sitting on on the same color oversprayed paper.
 
This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top